مشخصات پژوهش

The increase in global energy consumption leads to international commitments to replace fossil fuels and reduce environmental consequences. To improve and reduce the imbalance between the production and use of renewable energy, new ways should be considered for the distribution, and transmission, storage of global en- ergy. Liquid hydrogen is a clean fuel that can be used for long-term storage and transportation to distant places. High energy consumption, losses due to boil-off gas, and low exergy efficiency in hydrogen liquefaction units are the main challenges. Waste heat recovery from various industries in the form of refrigeration can be used in hydrogen production and liquefaction. This study proposes an innovative process configuration for the gener- ation of liquid hydrogen. The proposed process consists of a polymer electrolyte membrane electrolyzer, a Kalina power unit, a cascade absorption-compression refrigeration cycle, and three multi-component refrigerant cascade processes. The simulation of the proposed structure is performed in ASPEN HYSYS and m-file MATLAB. The verification is conducted highly accurately based on reference data. The proposed hybrid configuration produces 2066 kmol/h liquid hydrogen, 1033 kmol/h oxygen, and 14,572 kmol/h hot water using a power consumption of 272.2 MW. The proposed system’s energy, exergy, pinch, and sensitivity are analyzed to give a better insight into its capabilities. Results show the total specific energy consumption of the present study is lower than similar studies in this field. In addition, the cooling capacity per unit flue gas mass flow rate obtained in the present study is 4.70 % and 7.69 % higher than similar studies, respectively. Also, the exergy efficiency of the proposed structure is 23.58 %, demonstrating an increase compared to the reference data. The exergy analysis indicated the highest exergy destruction was related to the PEM electrolyzer, followed by heat ex- changers and reactors. Minimum pin